SUPREMATouch
102
Maintenance and Service
MSA
US
Selection of the Configuration
Touch the desired configuration to select it. Press OK to copy the selected configuration to other
MDO and/or MCP modules.
NOTE: If a configuration is transferred to the SUPREMATouch with the "SUPREMA Manager",
this configuration is always saved in the MDO. If you are not sure that the configuration was dis-
tributed to the system, the configuration of MDO is to be selected.
Removal of entries from a configuration
If removing measuring points from a configuration, care should be taken to ensure that all param-
eters of these measuring points [settings, connections, etc.] are deleted in the SUPREMATouch
before the new configuration is transferred to the SUPREMATouch.
If the system still contains parameters from measuring points that are no longer configured after
re-starting with reduced configuration, the SUPREMATouch stops with a SYSTEM FAILURE with
the status message "system start in progress…".
Corrective measure: Delete the invalid parameter with the PC program "SUPREMA Manager".
Communication with the SUPREMATouch is possible in this system status
To Next Page
Loading...
