MSA SUPREMATouch - 12 Connection of Peripherals; Connection of a Pc;Laptop

MSA AUER
MSA
Connection of Peripherals
SUPREMA
225
US
12 Connection of Peripherals
To simplify the operation (especially the configuration) of the SUPREMA, a PC or laptop with op-
erating software can be connected using different connectors.
A protocol printer can be connected via the RS 232-B interface on the MST.
12.1 Connection of a PC/Laptop
For this connection, you can use either the RS 232-A port on the MST10 module or the RS 232/
USB port on the MDO-20 module.
NOTE: No more than one PC/laptop may be connected to the SUPREMA system at one time,
even if more than one USB/RS232 port is available.
Connecting cable: RS 232 extension, 9-pin SUB-D connector, plug/jack (do not use a null mo-
dem cable!) or miniUSB.
To connect a PC/laptop to the MDO-20 module, the front panel screwing has to be loosened, and
the front panel must be dropped.
Fig. 163 MDO Module, RS 232 port
The terminal assignment of the RS 232/USB port on the MDO-20 module is the same as that used
for the RS 232-A port on the MST10 module (Chapter 10.10).
The MST module is mounted on the rear of the rack, behind Slot 1–3.