SUPREMATouch
132
Installation
MSA
US
Standards and Guidelines
Strict adherence to the specifications and regulations applicable to installation, start-up, operation,
and maintenance is required.
The system was developed in correspondence with the following standards and directives and
has to be installed, operated and maintain according to this standards.
General:
10.2 Installation, Step by Step
Unpack and inspect the device or its components.
NOTE: Follow the instructions for components subject to damage from static electricity!
EN 60079-29-2 Gas detectors - Selection, installation, use and maintenance of detectors
for flammable gases and oxygen.
IEC 61508 Functional safety of electrical/electronic/programmable electronic safety-
related systems. (In conjunction with DIN 19251, Requirements and Meas-
ures for Ensuring Safe Operation and DIN 19250, Basic Safety Considera-
tions).
EN 50270 Electromagnetic Compatibility. Electrical apparatus for the detection and
measurement of combustible gases, toxic gases or oxygen.
EN 61000-6-3 Electromagnetic Compatibility. Generic emission standard.Residential,
commercial and light industry.
EN 60079-29-1 Gas detectors - Performance requirements of detectors for flammable gas-
es
EN 50104 Electrical apparatus for the detection and measurement of oxygen; Per-
formance requirements for operating and test method.
EN 50271 Electrical apparatus for the detection and measurement of combustible
gases, toxic gases or oxygen – Requirements and tests for apparatus using
software and/or digital technologies.
EN 45544 Electrical apparatus used for the direct detection and direct concentration
measurement of toxic gases and vapours
EN 50402 Electrical apparatus for the detection and measurement of combustible or
toxic gases or vapours or of oxygen - Requirements on the functional safety
of fixed gas detection systems
WARNING
The area where the modules are installed must be outside of a hazardous area Zone 0, 1 or 2
and be free of ignitable, explosive or corrosive gases. Sensor installation at the SUPREMA must
be carried out according to Guideline EN 60079-14.
To Next Page
Loading...
