Startup
SUPREMATouch
213
US
11.2 System Configuration
The SUPREMA requires accurate data about the system structure for system control and error
detection. This includes information such as the used modules and their locations in the system,
connected power supplies as well as the number and location of the measuring points and Alarm
outputs. During commissioning, these data must be entered once into the system.
The required configuration file can be created with the PC program "SUPREMA Manager". This
program can then be used to transfer the configuration to the SUPREMA. (See Section 8 for ver-
sion and order number).
If the current system structure does not match the stored configuration, a SYSTEM FAILURE is
displayed and entries are recorded in the logbook of SUPREMA after it has started and also during
operation.
NOTE: The SUPREMA must always be restarted by switching off and on after configuration to ac-
tivate the new configuration.
PC program SUPREMA Manager
The program SUPREMA Manager allows you to create and manage the data of multiple SUPRE-
MA systems. The database can include the following information:
- System configuration
- Measuring point data
- Digital output Data
- System logs
The operating instructions include a CD-ROM where you can find the SUPREMA Manager pro-
gram. This program runs on Windows 7, Vista and XP (SP3).
Installation
- Insert the CD-ROM into your computer.
- The installation wizard starts automatically. Follow the instructions of the installation wizard.
- Start the SUPREMA Manager program on your system.
Creating a system configuration
Upon starting the program for the first time, the window for selecting the database path will be
opened automatically. Choose there the place your database will be located on your PC.
To Next Page
Loading...
