60
2019 MST Global Commercial in Confidence
XON Digital Plat
orm
User Manual
Revision A
Self-check Settings
To enable automatic configuration from a TFTP server, tick (enable) the Self check checkbox, enter the
desired Self check interval (default is 300 seconds) and TFTP Server Address, then click the Save.
Change Numbers
The two change numbers shown here are timestamps (formatted as YYYYMMDDhhmmss) showing the
last time the device's settings were updated via TFTP. The Site Change Number refers to general site
settings applied to all devices, whereas the Device Change Number refers to specific settings applied
to this device.
7.5.2 Configuring SNMP Settings
The SNMP screen contains Simple Network Management Protocol settings. SNMP is a protocol used by
the ICA and 3rd party SNMP browsers to monitor the status of compatible devices on the network. At
present, the ICA only uses this protocol to monitor for Port Up/Port Down errors on AXON Core and is not
affected by the settings below.
To Next Page
Loading...
Need help?
General
