69
2019 MST Global Commercial in Confidence
XON Digital Plat
orm
User Manual
Revision A
Note: After a unit is reset to factory defaults, it will have a single wireless network on channel 6 with
the name "AP------" (the last six digits of the unit's MAC address), WPA2-AES security enabled
and the password "minesite".
NOTE: After a unit is reset to factory defaults, it will have a single wireless network on
channel 6 with the name "AP------" (the last six digits of the unit's MAC address), WPA2-
AES security enable and the password "minesite".
Configuring WPA Settings
WPA provides a higher level of security. WPA-Personal and WPA-Enterprise are variants of Wi-Fi
Protected Access (WPA). WPA-Enterprise requires an external RADIUS server.
To configure WPA settings:
1. Select the WPA mode from the drop-down box.
2. Select the Cipher Type from the drop-down box. By default, it is set at AES.
3. Enter the Pre-Shared Key in the supplied field (applicable to WPA Personal security mode).
The key must be at least 8 alphanumeric characters in length.
4. Enter Network Key Rotation Interval in the supplied field. By default, it is 600 seconds.
This is the amount of time before the group key (used for broadcast and multicast data
encryption) is changed.
5. Click Save Settings
Configuring WEP Security Settings
7.5.6 Configuring EAP (Extensible Authentication Protocol)
The Wireless EAP configuration screen is used to configure wireless authentication by a RADIUS server
(as used by WPA Enterprise). The configuration screen is shown in Figure 32: Wireless EAP configuration
Figure 32: Wireless EAP configuration
To Next Page
Loading...
Need help?
General
