7.12.7 Engine coolant – Sample extraction and analysis
Preconditions
☑Engine is stopped and starting disabled.
☑MTU Fluids and Lubricants Specifications (A001061/..) are available.
Special tools, Material, Spare parts
Designation / Use Part No. Qty.
MTU test kit
5605892099/00 1
WARNING
Coolant is hot and under pressure.
Risk of injury and scalding!
• Let the engine cool down.
• Wear protective clothing, gloves, and goggles / safety mask.
Engine coolant – Sample extraction and analysis
1. Turn breather valve on coolant expansion tank counterclockwise to the first stop and allow pressure to
escape.
2. Continue to turn breather valve counterclockwise and remove.
3. Draw off precipitated corrosion inhibitor oil from expansion tank and dispose of oil.
4. Draw off approx. 1 liter coolant and drain into a clean container.
5. Using the equipment and chemicals from the MTU test kit, examine coolant for:
• antifreeze concentration;
• corrosion inhibitor concentration;
• pH value.
6. Fit breather valve and close it.
7. Engine coolant change intervals (→ MTU Fluids and Lubricants Specifications A001061/..).
114 | Task Description | MS150118/00E 2014-07
TIM-ID: 0000014607 - 002
To Next Page
Loading...
