MTU 12V2000B26F - Wiring (General) for Engine;Gearbox;Unit

7.17 Wiring (General) for Engine/Gearbox/Unit
7.17.1 Еngine wiring ‒ Check
Preconditions
☑Engine is stopped and starting disabled.
Special tools, Material, Spare parts
Designation / Use Part No. Qty.
Isopropyl alcohol
X00058037 1
Еngine wiring ‒ Check
1. Check securing screws of cable clamps on engine and tighten loose threaded connections.
2. Ensure that cables are fixed in their clamps and cannot swing freely.
3. Check if all cable clips are closed and intact.
4. Replace faulty cable clips.
5. Check that cable clamps are firm, tighten loose cable clamps.
6. Replace faulty cable clamps.
7. Visually inspect the following electrical line components for damage:
• Connector housing
• Contacts
• Sockets
• Cables and terminals
• Plug-in contacts
Result: Contact Service if cable conductors are damaged.
Note: Close male connectors that are not plugged in with the protective cap supplied.
8. Clean dirty connector housings, sockets and contacts using isopropyl alcohol.
9. Ensure that all sensor connectors are securely engaged.
MS150118/00E 2014-07 | Task Description | 131
TIM-ID: 0000000029 - 021