14. Tighten union nut (3) on HP fuel line (2) with torque wrench to the specified tightening torque.
Name Size Type Lubricant Value/Standard
Union nut M16 Tightening torque (Engine oil) 37 Nm +3 Nm
Final steps
1. Clean mating faces on cylinder head and charge-air pipe.
2. Check gaskets for damage and replace them, if required.
3. Coat gaskets with assembly compound and place on cylinder head.
4. Install leak-off-fuel lines.
5. Install charge-air pipes.
6. Install engine control system (→ Page 129).
7. Open fuel supply line.
8. Vent fuel system (→ Page 85).
84 | Task Description | MS150118/00E 2014-07
TIM-ID: 0000050910 - 002
To Next Page
Loading...
