Appendix A – Application Programming Interface (API)
Multi-Tech Systems, Inc. MultiModem® iSMS User Guide for Administrators 82
• modem Modem index to send SMS (this is only for the SF 400/800 models)
Range : 1 to 4 for SF 400
1 to 8 for SF 800
0 for any modem (Send API job will be distributed via all the available
modems)
If modem is not specified in the request, send API job will be distributed via all the
available modems.
• group The pre-defined group name(s) must be given within double quotes.
The maximum size of group name is 50 bytes.
• text The message text to be sent.
Enable Extended ASCII in the MultiModem iSMS to send both ASCII and extended ASCII
characters. By default, Extended ASCII is disabled, and the message can have only ASCII
characters.
If Unicode is enabled (and if enc is not specified in request), SMS text should only be in
Hexadecimal form.
If Extended ASCII and Unicode are disabled and spanned SMS value is 1, a maximum of
160 characters can be sent.
If Extended ASCII is enabled and spanned SMS value is 1, a maximum of 140 characters
can be sent.
If Unicode is enabled and spanned SMS value is 1, a maximum of 70 characters can be
sent.
If the spanned SMS value is more than 1, the maximum number of characters allowed for each
encoding scheme is defined as follows (where n represents the span value):
ASCII – n * 154 characters
Extended ASCII – n * 134 characters
Unicode – n * 64 characters
Any characters entered beyond the allowed limit will be chopped off.
Downloaded from Elcodis.com electronic components distributor
To Next Page
Loading...
