Maintenance Manual – SC Cutting Plotter
10 AP-74030, Rev / B
1.2. SC cutting plotter, environment.
The location where you set up your equipment is very important. Please see to it that it meets following
conditions :
q Power supply of 100 to 120 VAC 50/60 Hz or 200 to 240 VAC 50/60 Hz.
q Ambient conditions :
o Operating environment
§ Temperature : 5°C to 40°C (41°F to 104°F)
§ Humidity : 35% - 75% non-condensation
o Recommended environment
§ Temperature : room temperature 16°C to 32°C (61°F to 90°F)
§ Humidity : 50% to 65% non-condensation
o Variation rate
§ Temperature : 2°C per hour
§ Humidity : 5% per hour
o Storage environment
§ Temperature : 0°C to 50°C (32°F to 122°F)
q Please protect your cutter from moisture, dust, draughts and direct sunlight. It is best to keep
your machine away from open windows and air-conditioners.
q See to it that there is an adequate space around the cutter so that ventilation is not obstructed.
q Avoid unnecessary vibrations and set up your cutter on a level surface.
q When selecting a place for your cutter, leave at least 90 cm in front and 90 cm at the rear.
To Next Page
Loading...
