MUTOH SC-650 - Backup Plots (On Paper Only)

Maintenance Manual – SC Cutting Plotter
35 AP-74030, Rev / B
5.2.6. Backup plots (on paper only).
Step 1 : Power on the unit in diagnostic mode.
Step 2 : Press the [ORIGIN] key until 50% LED is on.
Step 3 : Put a pen in the head and load some paper (Min. A3 size).
Step 4 : Press the [VALUE ] key (Unit will start initialising, wait until finished).
Step 5 : Pres the [VALUE ] key.
Step 6 : The next key will determine the kind of plot.
· [VALUE ¯] selects USER PARAMETERS backup.
· [VALUE ] selects ADJUSTMENT VALUES backup.
· [VALUE ¯] (Unit will start plotting, wait until finished.)
Step 7 : When finished 1 of the 2 plots, you can change the sheet and select the other one without
powering off the machine.
Þ Press the [VALUE ] key
Þ Select with the [VALUE ¯] and [VALUE ] key the desired plot.
Þ Press the [VALUE ¯] key (Unit will start plotting, wait until finished).
Step 8 : Power off.