NCR 7454 - Page 106

3-14 Chapter 3: Setup
No
Yes
Reset Configuration Data
1. Move the cursor to the Reset Configuration Data option.
2. Press Enter and then select the desired setting from the drop-down
menu.
• Select Yes if you want to clear the System Configuration Data.
PS/2 Mouse
This option is used to configure the parallel port.
1. Move the cursor to the PS/2 Mouse option.
2. Press Enter and then select the desired setting from the drop-down
menu.
• Selecting Disabled prevents any installed PS/2 mouse on the
Touch Screen from functioning, but frees up IRQ 12.
• Selecting Enabled forces the PS/2 mouse port to be enabled
regardless if a mouse is present.
• Selecting Auto detect enables the PS/2 mouse only if present.
Disabled
Enabled
Auto