Chapter 3: Setup 3-13
No
Yes
1. Move the cursor to the Selectable ROM x option.
2. Press Enter and then select the desired setting from the drop-down
menu.
• Disabled – do not load ROM
• Enabled – load ROM in next boot
Note: Due to available space limitations (48 K), only enable the
required ROMs. Refer to the following table for ROM usage
information.
ROM Use
On-board Intel LAN This is the Boot ROM for the On-board Intel
Ethernet
Lucent WaveLAN
PXE Base
These ROMs (both parts required) are for use
with Lucent WaveLAN ROM 80211 cards.
Plug and Play O/S
1. Move the cursor to the Plug and Play O/S option.
2. Press Enter and then select the desired setting from the drop-down
menu.
• Select Yes if you are using a Plug and Play capable operating
system (Win95 or Win98).
• Select No if you need the BIOS to configure non-boot devices.
Disabled
Enabled
To Next Page
Loading...
