3-52 Chapter 3: Setup
PCI/PNP IRQ Resource Exclusion
This option reserves specific IRQs for use by a legacy device.
1. Move the cursor to the PCI/PNP IRQ Resource Exclusion option.
2. Press Enter and select the desired IRQ from the drop-down menu.
3. Press Enter and select the desired setting from the drop-down
menu.
• Available – permits the selected IRQ to be used by devices
other than a legacy device
• Reserved – reserves the selected IRQ for use by a legacy device
Boot-Time Diagnostic Screen
This option displays the boot-time diagnostic screen during boot.
1. Move the cursor to the Boot-Time Diagnostic Screen option.
2. Press Enter and then select the desired setting from the drop-down
menu.
Note: If the boot-time diagnostic screen is disabled, you will see
the logo instead of the post results. If an error occurs, the terminal
will beep and may wait for user input before booting, but not
automatically display an error message. You may display the boot-
time diagnostic screen by pressing ESC during boot-time. Pressing
ESC will also cause the terminal to display the Boot Menu instead
of automatically following the configured boot sequence specified
in Setup.
Available
Reserved
Disabled
Enabled
To Next Page
Loading...
