NEC ELECTRA ELITE IPK II - Page 805

Electra Elite IPK II Document Revision 1
Station Message Detail Recording 2 - 783
SMDR with a CTU Adapter
Was the
extension, on
which the CTU
Adapter is to
be installed,
previously
connected to
the system?
In 35-01-01, set the SMDR output
to ‘4’ for CTA/CTU
Disconnect the
telephone and
undefine (set
to 0) the
multiline
terminal’s port
in 10-03-01.
Go to
‘A’.
The CTU Adapter
REQUIRES an AC/CD
power adapter.
Start
Do NOT plug in the multiline
terminal with the CTU Adapter.
Yes
No
In 35-01-02, define the extension number of
the multiline terminal with the CTU Adapter.
Install the CTU USB driver. Select ‘non-procedure’
service during the installation of SMDR.
When connecting to the USB port using a communications
program (such as HyperTerminal), you can determine the
COM port used by checking the ports listing in the Device
Manager (right-click on “My Computer” and click on
“Manage”).
The baud rate selected in the HyperTerminal does not
matter with the USB connection.
Attach ferrite beads to the AC-R power cable and USB
cables. (Install on the ends closest to the adapter.)
Check 10-03-04 for the multiline terminal.
Does it show the CTU installed?
Disconnect the telephone.
Undefine the multiline
terminal’s port in 10-03-01.
Remove the CTU Adapter.
No
Refer to the
Electra Elite IPK
II System
Hardware
Manual for
further
installation
details for the
CTU Adapter.
Set the dip switches on the CTU Adapter to pins
2, 5, 6 On (up); 1, 3, 4, 7, 8 Off (down).
Set 15-02-19 to ‘0’ for the
extension which will have the CTU
installed. (With PCPro/WebPro,
select ‘Direct Print Mode’.)
Without the line cord connected to the multiline terminal, install
the CTU Adapter onto the multiline terminal and connect the AC/
DC adapter.
Connect the line cord to the multiline terminal.
Wait one minute for the system to recognize the adapter.
Continue the USB cable to the adapter and PC.
No
You may
want to
remove the
wall mount
bracket to
allow easier
installation
Yes