2 15-07-01
tells you to enter the programming mode, dial 150701 from the telephone dial pad. After you do, you
will see the message “15-07-01 TEL” on the first line of the telephone display. This indicates the pro-
gram number (15-07), item number (01), and that the options are being set for the extension. The sec-
ond row of the display “KY01 =
*
01” indicates that Key 01 is being programmed with the entry of
*
01.
The third row allows you to move the cursor to the left or right, depending on which arrow is pressed.
To learn how to enter the programming mode, refer to How to Enter Programming Mode on this page.
SECTION 3 HOW TO ENTER PROGRAMMING MODE
To enter programming mode :
1 Go to any working display telephone.
In a newly installed system, use extension (port 1).
2 Do not lift the handset.
3 Press Speaker.
4 #
*
#
*
.
5 Dial the system password + Hold. Refer to the following table for the default system passwords. To
change the passwords, use 90-02 : Programming Password Setup on page 2-489.
Password User Name Level Programs at this Level
******
nec-i 1 (MF)
Manufacture Level (MF) :
80-02, 81-04, 81-05, 82-02, 82-05
12345678 tech 2 (IN)
Installation (IN) :
All programs in this section not listed for MF, SA, & SB
0000 admin1 3 (SA)
System Administrator - Level 1 (SA) :
10-01, 10-02, 10-12, 10-13, 10-14, 10-15, 10-16, 10-17, 10-18, 10-23, 10-
24, 10-25, 10-28, 10-29, 10-45, 12-02, 12-03, 12-04, 12-08, 15-01, 15-07,
15-09, 15-10, 15-11, 20-16, 20-34, 21-07, 21-14, 22-04, 22-11, 22-17, 25-
08, 30-03, 30-04, 32-02, 45-02, 84-22, 90-03, 90-04, 90-06, 90-07, 90-19,
90-57, 90-58, 90-59, 90-65
9999 admin2 4 (SB)
System Administrator - Level 2 (SB) :
13-04, 13-05, 13-06, 13-11, 21-20
15-07-01 TEL200
KY01 = *01
(Multiline Telephone)
15-07-01 TEL
KY01 = *01
- +
(IP Phone) (Version 1.5)
Program Mode
ISSUE 1.1SL1000
Introduction1-2
To Next Page
Loading...
