When you want to ... Telephone Programming
All Clear Flash
Register Hold
Enter
Go Back to Prior Screen Mute
Clear / Back
Move Cursor Jump Up/Down DND (V1.5 Added) or DND / CONF
Delete single character Clear / Back
Next Page -
Toggle between Number/Character Help
While in a Entering Number
Prior Page -
Quit the programming Speaker
Exit
Move Cursor to Left Cursor Key (Left)
Change Program Number -
Change Index Number
Change Program Number -
Change Index Number
Move Cursor to Right Cursor Key (Right)
SECTION 6 PROGRAMMING NAMES AND TEXT MESSAGES
Several programs (e.g., Program 20-16 : Selectable Display Messages) require you to enter text. Use
the following chart when entering and editing text. When using the keypad digits, press the key once
for the first character, twice for the second character, etc. For example, to enter a C, press the key 2
three times. Press the key six times to display the lower case letter. The name can be up to 12 digits
long.
Table 1-2 Keys for Entering Names
Use this keypad digit ... When you want to ...
1
Enter characters : 1@[¥]^_`{|}
ÁÀÂÃÅÆÇÉÊìó0
2 Enter characters : A-C, a-c, 2.
3 Enter characters : D-F, d-f, 3.
4 Enter characters : G-I, g-i, 4.
5 Enter characters : J-L, j-l, 5.
6 Enter characters : M-O, m-o, 6.
7 Enter characters : P-S, p-s, 7.
8 Enter characters : T-V, t-v, 8.
9 Enter characters : W-Z, w-z, 9.
0 Enter characters : 0!“#$%&’()ôõúåäæöüαεθВ
*
Enter characters :
*
+,-./:;<=>?πΣσΩ∞¢£
#
# = Accepts an entry (only required if two letters on the same key are needed - ex :
TOM). Pressing # again = Space. (In system programming mode, use the right arrow
Softkey instead to accept and/or add a space.)
ISSUE 1.1SL1000
Introduction1-4
To Next Page
Loading...
