NEC SL100 - Incoming Virtual Extension Ring Tone Setup

Program 15 : Extension, Basic Setup
15-08 : Incoming Virtual Extension Ring Tone Setup
Level
IN
Description
Use Program 15-08 : Incoming Virtual Extension Ring Tone Setup to assign a ring tone range (0 ~
4) to incoming virtual extensions assigned to a Virtual Extension key (Program 15-07). If you enable
ringing for the key in Program 15-09, the key rings with the tone you set in this program. Also see Pro-
gram 22-03. The chart below shows the available tones. There are 126 available extension ports.
Input Data
Extension Number Maximum four digits
Item No. Incoming Ring Pattern Default Description
01 0 = Tone Pattern 1
1 = Tone Pattern 2
2 = Tone Pattern 3
3 = Tone Pattern 4
4 = Incoming Ring Tone Extension
5 = Tone pattern 5
6 = Tone pattern 6
7 = Tone pattern 7
0 = Tone Pattern 1 When an extension or a virtual ex-
tension is assigned to the function
key on the key telephone, select the
ring tone when receiving a call on
that key.
Program 15-08 - Incoming Signal Frequency Patterns
Incoming Signal
Frequency Pattern Type Frequency 1 Frequency 2 Modulation
Pattern 1 High
Middle
Low
1100 Hz
660 Hz
520 Hz
1400 Hz
760 Hz
660 Hz
16 Hz
16 Hz
16 Hz
Pattern 2 High
Middle
Low
1100 Hz
660 Hz
520 Hz
1400 Hz
760 Hz
660 Hz
8Hz
8Hz
8Hz
Pattern 3 High
Middle
Low
2000 Hz
1400 Hz
1100 Hz
760 Hz
660 Hz
540 Hz
16 Hz
16 Hz
16 Hz
Pattern 4 High
Middle
Low
2000 Hz
1400 Hz
1100 Hz
760 Hz
660 Hz
540 Hz
8Hz
8Hz
8Hz
Internal Incoming Sig-
nal Frequency
High
Middle
Low
1100 Hz
660 Hz
520 Hz
1400 Hz
760 Hz
660 Hz
8Hz
8Hz
8Hz
Conditions
None
Feature Cross Reference
None
ISSUE 1.1 SL1000
Program
15
Programming Manual 2-135