Use this keypad digit ... When you want to ...
Clear/Back Clear the character entry one character at a time.
Flash Clear all the entries from the point of the flashing cursor and to the right.
SECTION 7 USING SOFTKEYS FOR PROGRAMMING
(This Feature is available for V1.5 IP Phone Only.)
Each Display telephone with Softkeys provides interactive Softkeys for intuitive feature access. The
options for these keys will automatically change depending on where you are in the system program-
ming. Simply press the Softkey located below the option you wish and the display will change accord-
ingly.
Pressing the Cursor key Up or Down will scroll between the menus.
SECTION 8 WHAT THE SOFTKEY DISPLAY PROMPTS MEAN
(This Feature is available for V1.5 IP Phone Only.)
When using a display telephone in programming mode, various Softkey options are displayed. These
keys will allow you to easily select, scan, or move through the programs.
Table 1-3 Softkey Display Prompts
Softkey Display Prompts
If you press this Softkey
...
The system will ...
back
Go back one step in the program display.
You can press Cursor Key (UP) or Cursor Key (Down) to scroll forward or backward through a
list of programs.
Scroll down through the available programs.
Scroll up through the available programs.
select Select the currently displayed program.
Move the cursor to the left.
Move the cursor to the right.
- 1 Move back through the available program options.
_
Program Mode
Base Service OP1 OP2
_
Program Mode
Hard Mtnance
ISSUE 1.1 SL1000
Programming Manual 1-5
To Next Page
Loading...
