NEC SL100 - Page 145

Item
No.
Item Input Data Default
Related Pro-
gram
Note
09 Caller ID Function - For External
Module
Enable (1) or disable (0) the Caller
ID FSK signal for an external Caller
ID module or a 3rd party vendor
telephone with Caller ID display.
Important:
If voice mail is used, this setting
must be disabled for the system in-
tegration codes to be correct.
With a Single Line Tele-
phone, this must be set to 0
for incoming callers to have
a talk path.
0=Disable(Off)
1 = Enable (On)
0
10 Caller ID Name
Determine if an extension user tele-
phone should display the Caller ID
name.
0=Disable
1 = Enable
1 15-03-09
11 Caller ID Type
Determine whether the Caller ID
type is FSK or DTMF.
0 = FSK
1 = DTMF
0
12 Fixed Cadence 0 = Normal
1 = Fixed
1
14 Forwarded Caller ID Display Mode
Determine what the display shows
when a multiline terminal receives a
forwarded outside call.
0 = Calling Extension
Number (Calling)
1 = External Caller ID
(Forward)
0
15 Disconnect without dial after
hooking hold
Determine whether or not to discon-
nect a held call when on-hook with-
out any dialing after hooking-hold.
0 = Normal
1 = Disconnect
0
16 Special DTMF Protocol Send
Determine whether or not to send
the extension number of the phone
forwarded to the extension when
Program 15-03-04 is set to Special
(1) and not in the VM group.
0=No
1=Yes
0 45-01-16
ISSUE 1.1 SL1000
Program
15
Programming Manual 2-123