NEC SL100 - Page 174

Item
No.
Item Input Data Default
Related
Program
Note
09 Disconnect Supervision
Use this option to enable
or disable disconnect su-
pervision for the system
trunks.
0=Disable(Off)
1 = Enable (On)
1
10 Time Before Shifting to
Power-Saving Mode
0=NoShift
1=1minute
2=2minutes
3=4minutes
4=8minutes
5=16minutes
6=32minutes
7=64minutes
0 15-02-18 (V1.5
Added)
11 Handsfree Microphone
Control
Use this option to control
the setting for Multiline
Terminal Handsfree micro-
phone after being discon-
nected and reconnected. If
set to 0, the microphone is
always off when the termi-
nal is reconnected. If set
to 1, the microphone re-
mains in the same state it
was in when the terminal
is reconnected.
0=Off
1=On
1
12 Forced Intercom Ring
(ICM Call Type)
Use this option to enable
or disable Forced Inter-
com Ringing. If enabled,
incoming Intercom calls
normally ring. If disabled,
Intercom calls voice-
announce.
0 = Disable (Voice)
1 = Enable (Signal)
1
15 Caller ID Display Mode 0 = Name and Number (Both)
1 = Name
2 = Number
0
18 Dialing Record Display
Time
0 ~ 64800 seconds 30 seconds
19 DSS Key - Virtual Exten-
sion Mode
Sets the mode of a virtual
extension key that ap-
pears on a DSS console.
0=No
1=Yes
0
24 LCD scroll mode 0 = Character
1 = Dot
0 (V1.5
Added)
Conditions
None
Feature Cross Reference
None
ISSUE 1.1SL1000
Program
20
Program 20 : System Option Setup2-152