NEC SL100 - Page 240

Item
No.
Item Input Data Default
Related
Program
Note
11 Intercom Call Restriction
Determines if incoming and outgoing
intercom calls are allowed.
0 = Disable (No)
1 = Enable (Yes)
0
12 PBX Call Restriction
Use this option to set how the system
Toll Restricts calls over PBX trunks. If
you enable PBX Toll Restriction, the
system begins Toll Restriction after
the PBX access code. The user can-
not dial a PBX extension. If you dis-
able PBX Toll Restriction, the system
only restricts calls that contain the
PBX access code. The system does
not restrict calls to PBX extensions.
Refer to the PBX compatibility fea-
ture. Make sure Program 21-05-04
(Maximum Number of Digits Table
Assignment) allows for PBX Toll Call
Dialing (normally 12 digits).
0 = Disable (No)
1 = Enable (Yes)
0
13 Restriction of Tie Line Calls
It chooses whether the toll restriction
of the dial set up by 34-08 is enabled
or disabled.
0 = Disable (No)
1 = Enable (Yes)
0 34-08
14 Trunk Transfer Restriction on In-
complete Dial
If this program is set to 1, you can
transfer the outgoing trunk which you
dialed incompletely.
0 = Not allow
1 = Allow
0
15 Common Hold Restriction on In-
complete Dial
If this program is set to 1, you can
hold the outgoing trunk which you
dialed in restriction check.
0 = Not allow
1 = Allow
0
Conditions
None
Feature Cross Reference
None
ISSUE 1.1SL1000
Program
21
Program 21 : Outgoing Call Setup2-218