Item No. Item Input Data Default
06 Message Waiting Lamp
(Update MW Lamp)
Use this option to enable or disable Message Wait-
ing light at the extension associated with the Sub-
scriber mailbox. For Subscriber Mailboxes, you
should leave this option enabled. For Guest Mail-
boxes, you should leave this option disabled.
0 = No (Disabled)
1 = Yes (Enabled)
1
07 Auto Attendant Direct to Voice Mail
Use this option to enable or disable Auto Attendant
Direct to VM. When a subscriber enables Auto At-
tendant Direct to VM, an Automated Attendant caller
routes directly to the mailbox, hears the greeting,
and is asked to leave a message. A subscriber can
also enable Auto Attendant Direct to VM while re-
cording their mailbox greeting.
0 = No (Disabled)
1 = Yes (Enabled)
0
08 Forced Unscreened Transfer
(Forced UTRF)
Use this option to enable or disable Automated At-
tendant Forced Unscreened Transfer for the Sub-
scriber Mailbox. If enabled, each Screened Transfer
(TRF) to the extension is converted to an Un-
screened Transfer (UTRF). If disabled, Screened
Transfers from the Automated Attendant occur nor-
mally.
0 = No (Disabled)
1 = Yes (Enabled)
0
09 Auto Time Stamp
Use this option to enable or disable Auto Time
Stamp for the Subscriber Mailbox. If enabled, after
the subscriber listens to a message InMail an-
nounces the time and date the message was left.
Auto Time Stamp also announces the message
sender (if known).
A subscriber can also enable Auto Time Stamp from
their mailbox.
0 = No (Disabled)
1 = Yes (Enabled)
0
10 System Administrator
(System Admin)
Use this option to designate the Subscriber Mailbox
as a System Administrator. This allows the sub-
scriber to use the options after logging onto their
mailbox.
0 = No (Disabled)
1 = Yes (Enabled)
0
11 Dialing Option
Dialing Option provides additional dialing options for
Next Call Routing Mailbox calls (see Next Call Rout-
ing Mailbox below). If enabled, a caller who ac-
cesses the Subscriber Mailbox to leave a message
can dial any option in the Next Call Routing Mailbox
Dial Action Table. If disabled, the caller can dial only
0 (to use the Next Call Routing Mailbox 0 action).
0 = No (Disabled)
1 = Yes (Enabled)
0
12 Next Call Routing Mailbox
(Next CR Mbox)
Use this option to assign a Next Call Routing Mail-
box to the Subscriber Mailbox. This provides callers
with additional dialing options while listening to a
Subscriber Mailbox recorded or default greeting.
The digits the caller can dial depends on the setting
of the Next Call Routing Mailbox and Alternate Next
Call Routing Mailbox options.
0~32
(0 = Undefined)
1
(Call Routing
Mailbox 01)
By default, Call
Routing Mailbox
numbers are 01 =
16.
13 Directory List Number
Specify the Directory List number to which the
Group Mailbox belongs.
0 = None
1~8=ListNumber
*
=All
0
14 Voice Prompt Language Refer to
Table 2-9 47-06-14 De-
fault Table on the next page
.
2
15 Enable Paging 0=No
1=Yes
0
16 Paging Option 0 = RNA
1 = Immediate
0
17 Telephone User Interface 0 = Numeric interface
1 = Mnemonic interface
2 = Octel (future)
0
ISSUE 1.1 SL1000
Program
47
Programming Manual 2-379
To Next Page
Loading...
