6. Enter the name associated with the Speed Dialing number (display telephones only).
Key for Entering Names
Use this keypad digit . . . When you want to. . .
1 Enter characters: 1 @ [ ¥ ] ^ _ ` { | } Á À Â Ã Å Æ Ç É Ê ì ó 0
2 Enter characters: A-C, a-c, 2.
3 Enter characters: D-F, d-f, 3.
4 Enter characters: G-I, g-i, 4.
5 Enter characters: J-L, j-l, 5.
6 Enter characters: M-O, m-o, 6.
7 Enter characters: P-S, p-s, 7.
8 Enter characters: T-V, t-v, 8.
9 Enter characters: W-Z, w-z, 9.
0 Enter characters: 0 ! “ # $ % & ’ ( ) ô õ ú å ä æ ö ü α ε θ В
Enter characters:
+ , - . / : ; < = > ? π Σ σ Ω ∞ ¢ £
# # = Accepts an entry (only required if two letters on the same key are needed - ex:
TOM). Pressing # again = Space.
Clear/Back or DND/CONF
(SL1000) DND (SL1100)
Clear the character entry one character at a time.
Flash Clear all the entries from the point of the flashing cursor and to the right.
7. Press Hold key.
8. Press Speaker key to hang up.
To store a Station Speed Dialing number (Single Line Terminals only):
1. Lift the Handset.
2. Dial 855.
3. Dial the Station Speed Dial buffer number to be programmed (0~9).
1 = Station Speed Dial Buffer 1
2 = Station Speed Dial Buffer 2
3 = Station Speed Dial Buffer 3
4 = Station Speed Dial Buffer 4
5 = Station Speed Dial Buffer 5
6 = Station Speed Dial Buffer 6
7 = Station Speed Dial Buffer 7
8 = Station Speed Dial Buffer 8
9 = Station Speed Dial Buffer 9
0 = Station Speed Dial Buffer 10
4. Dial the telephone number you want to store (maximum of 36 digits).
Valid entries are 0~9, # and
.
A Single line set cannot program a pause or flash in a spd bin.
5. Hang up.
To dial a Station Speed Dialing number (Multiline Terminal):
1. Press Speaker key.
ISSUE 2.0
SL1000/SL1100
Features and Specifications Manual 1-11
A
To Next Page
Loading...
