SECTION 5
MAINTENANCE
75
3. Power-up the printer.
4. Open the Printer Toolbox. In the User
Interface window, press the “Eject
Service Station” button.
5. Once the Service Station has ejected; power OFF the printer. Press the ON/OFF button once and
wait about 45 seconds for the print engine to power off (all control panel light’s off). Then turn the
Main Power Switch OFF.
6. Slide the Service Station out of the Service Station slot.
CAUTION: Do not pull Station all the way out until you
disconnect the Ribbon Cable.
NOTE: It is a good idea to place an absorbent towel
under the Service Station as you remove it to prevent any
drips or leaks.
4. Disconnect the Ribbon Cable. Slide the Latch open on
the Service Station Circuit Board to release the Ribbon
Cable.
CAUTION! This latch can be broken if you pull it out
too far. Be careful!
5. Remove the Service Station completely from the print
engine and place it on a non-absorbent surface (plastic
bag) to protect the surface you are placing it on.
6. If you are replacing or re-installing the Service Station, please see the section titled
“Installing the Service Station”.
7. If you are cleaning or replacing items in the service station; please see the next section titled
“Cleaning the Service Station”.
To Next Page
Loading...
Need help?
General
