FS728TP Smart Switch Software User Manual
5-95 Configuring the Device Using Your Browser
v2.0, November 2006
Mapping DSCP Values to Queues
The DSCP to Queue Page contains fields for mapping DSCP settings to traffic queues. For
example, a packet with a DSCP tag value of 3 can be assigned to queue 2.
To map CoS values to queues:
1. Click Switch > QoS > Mapping > DSCP to Queue. The DSCP to Queue Page opens:
Figure 5-62
The DSCP to Queue Page contains the following fields:
– DSCP In – Displays the incoming packet’s DSCP value.
– Queue – Specifies the traffic-forwarding queue to which the DSCP priority is mapped.
Four traffic priority queues are supported.
2. Define the relevant fields.
3. Click . The DSCP to Queue settings are defined, and the device is updated.
To Next Page
Loading...
