FS728TP Smart Switch Software User Manual
5-91 Configuring the Device Using Your Browser
v2.0, November 2006
Configuring Bandwidth Settings
After packets are assigned to a queue, a scheduling scheme can be assigned to an interface, using
either:
• Committed Burst Size – Indicates the maximum number of data bits transmitted within a
specific time interval.
• Committed Information Rate – Indicates the rate that data is transmitted. The rate is
averaged over a minimum time increment.
The Bandwidth Page allows network managers to define the bandwidth settings for a specified
egress interface. Modifying queue scheduling affects the queue settings globally. Queue shaping
can be based per queue and/or per interface. Shaping is determined by the lower specified value.
The queue shaping type is selected in the Bandwidth Page.
To define bandwidth settings:
1. Click Switch > QoS > General > Bandwidth. The Bandwidth Page opens:
Figure 5-59
To Next Page
Loading...
