FS728TP Smart Switch Software User Manual
Configuring the Device Using Your Browser 5-36
v2.0, November 2006
Defining RADIUS Settings
Remote Authorization Dial-In User Service (RADIUS) servers provide additional security for
networks. RADIUS servers provide a centralized authentication method for web access.
The default parameters are user-defined, and are applied to newly defined RADIUS servers. If new
default parameters are not defined, the system default values are applied to newly defined
RADIUS servers.
To configure RADIUS servers:
1. Click System > Management Security > RADIUS. The RADIUS Page opens:
Figure 5-30
The RADIUS Page contains the following fields:
– Primary Server – Defines the RADIUS Primary Server authentication fields.
– Backup Server – Defines the RADIUS Backup Server authentication fields.
– Host IP Address – Defines the RADIUS Server IP address.
To Next Page
