NETGEAR ProSafe FS728TP - Getting Started

FS728TP Smart Switch Software User Manual
Configuring the Device Using Your Browser 5-2
v2.0, November 2006
Getting Started
This section describes setting browser interface options, and using the FS728TP switch’s home
page. This section includes the following sections:
• Opening the NETGEAR FS728TP Web Interface
• Understanding the Web Interface
• Using the NETGEAR Web Management System Buttons
Opening the NETGEAR FS728TP Web Interface
The NETGEAR FS728TP switch web interface can be accessed from any PC with a web browser.
To start the NETGEAR application:
1. Open a web browser.
2. Enter the device IP address in the address bar.
3. Press Enter. The Logon Page appears.
Figure 5-10
4. Enter “password” in the Password field.
5. Click . The NETGEAR FS728TP web interface displays.