NETGEAR ProSafe FS728TP - Main Screen > Switch Setting > Configuration Setting; Main Screen > Device Setting > Configuration Setting > Set

FS728TP Smart Switch Software User Manual
3-5 Smartwizard Discovery Program
v2.0, November 2006
Main Screen > Switch Setting > Configuration Setting
Select a switch by clicking on it. Then click Configuration Setting. The following screen appears.
From this screen, you can modify:.
• IP Address – Displays the currently configured IP address.
• Subnet Mask – Displays the currently configured Subnet Mask.
• Gateway – Displays the currently configured Gateway.
• System Name – Provides a user-defined system name field. The System Name field is to help
you keep track of your switches. The field can contain any combination of letters and
numbers.
• Location – Provides a user-defined field is to help you keep track of where this switch is. It
can contain any combination of letters and numbers.
• Password – Displays the default password is ‘password’.
• DHCP – DHCP automatically obtains the IP information for the switch.
• Product Name – Displays the Product Name.
• Mac Address – Displays the device MAC address.
Main Screen > Device Setting > Configuration Setting > Set
Click Set to enable the new settings. You must enter your password for these settings to be
accepted.
Figure 3-3