EasyManua.ls Logo

NETGEAR ProSafe FS728TP - Configuring File Uploads

NETGEAR ProSafe FS728TP
196 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
FS728TP Smart Switch Software User Manual
5-129 Configuring the Device Using Your Browser
v2.0, November 2006
Configuring File Uploads
To back up files:
1. Click Firmware > File Management > File Upload. The File Upload from Switch Page
opens:
Figure 5-85
The File Upload from Switch Page contains the following fields:
Firmware Upload from Switch
Configuration Upload from Switch
Firmware Upload from Switch
The Firmware section contains the following fields:
TFTP Server IP Address – Specifies the TFTP Server IP Address to which the firmware
upload file is uploaded.
Destination File Name – Specifies the destination file name to be uploaded.
Configuration Upload from Switch
The Configuration Upload from Switch section contains the following fields:

Table of Contents

Other manuals for NETGEAR ProSafe FS728TP

Related product manuals