NETGEAR ProSafe FS728TP - Defining Global Trap Settings

FS728TP Smart Switch Software User Manual
Configuring the Device Using Your Browser 5-116
v2.0, November 2006
Defining Global Trap Settings
The Global Trap Settings Page contains parameters for defining SNMP notification parameters.
To define SNMP notification global parameters:
1. Click Switch > Advanced > SNMP > Global Trap Settings. The Global Trap Settings Page
opens:
Figure 5-77
The Global Trap Settings Page contains the following fields:
– SNMP Notifications – Specifies whether the device can send SNMP notifications. The
possible field values are:
– Enable – Enables SNMP notifications.
– Disable – Disables SNMP notifications.
– Authentication Notifications – Specifies whether SNMP authentication failure
notification is enabled on the device. The possible field values are:
– Enable – Enables the device to send authentication failure notifications.
– Disable – Disables the device from sending authentication failure notifications.