Default Settings A-1
v2.0, November 2006
Appendix A
Default Settings
This appendix provides default settings for the NETGEAR Model FS728TP Smart Fast Ethernet
Switch. You can always configure the switch to default settings by using the Factory Reset
function from a Web browser.
Table 1: Default Settings
Feature FS728TP Default Setting
Port Speed Auto-negotiation
Port Duplex Auto-negotiation
Flow Control (half duplex) Enabled
Flow Control (full duplex) Enabled
IP Configuration DHCP enabled
Password password
VLAN 802.1q based VLAN
Link Aggregation (Trunk) Disabled
Traffic Prioritization (QoS) Optimized for flow control, all ports set normal priority
To Next Page
Loading...
