FS728TP Smart Switch Software User Manual
Configuring the Device Using Your Browser 5-32
v2.0, November 2006
– Max Entries – Specifies the number of MAC address that can be learned on the port. The
Max Entries field is enabled only if Locked is selected in the Set Port field. In addition, the
Limited Dynamic Lock mode is selected. The default is 1.
– Action – Indicates the action to be applied to packets arriving on a locked port. The
possible field values are:
– Forward – Forwards packets from an unknown source without learning the MAC
address.
– Discard – Discards packets from any unlearned source. This is the default value.
– Shutdown – Discards packets from any unlearned source and shuts down the port. The
port remains shut down until reactivated or until the device is reset.
– Trap – Enables traps when a packet is received on a locked port. The possible field values
are:
– Checked – Enables traps.
– Unchecked – Disables traps. This is the default value.
– Trap Frequency (Sec) – Indicates the frequency at which traps are sent. The field format
is in seconds. The default value is 10 seconds.
To Next Page
Loading...
