NETGEAR WAX204

(Continued)
DescriptionField
The IP subnet mask that applies to all four access point LAN ports. For more
information, see Change the LAN IP address and subnet settings [router mode]
on page 109.
IP Subnet Mask
The DHCP lease time. For more information, see Manage the DHCP server address
pool [router mode] on page 110.
DHCP Lease Time
DescriptionField
Internet Port
To change these settings, see, Use the Setup Wizard on page 36 or Manually set up the access point Internet
connection [router mode] on page 37.
The MAC address that applies to the access point WAN (Internet) port.MAC Address
The WAN IP address that the access point receives from your ISP (through your
modem) or the WAN IP address that you manually configured.
IP Address
The type of Internet connection that the access point uses, which can be DHCP
(the default setting), Static IP, PPPoE, PPTP, or L2TP.
Connection
The IP subnet mask that the access point uses.IP Subnet Mask
The IP address of the Domain Name System (DNS) server that the access point
uses.
Domain Name Server
This field always shows Internet Port (1 Gbps).WAN Preference
DescriptionField
Wireless Settings (2.4GHz) or Wireless Settings (5GHz )
To change these settings, see Basic WiFi and Radio Features on page 58 and Advanced WiFi and Radio Features
on page 187.
The name of the SSID (see Set up or change an open or secure WiFi network on
page 59).
Name
The country and region in which the access point is being used (see Change the
region of operation on page 188).
Region
The channel that the radio uses (see Change the channel for a radio on page 193).Channel
User Manual148Maintain and Monitor
WiFi 6 AX1800 Dual Band Wireless Access Point WAX204