Neural DSP Quad Cortex - Page 52

52
Modes
In the following example, you can see ve device blocks assigned
to different footswitches. Press the footswitches to engage or
disengage the blocks.
Once a block is assigned to a footswitch, the LED will illuminate
corresponding to the color of the assigned block.
The rst eight blocks created in the Preset will be assigned to
footswitches automatically. If your Preset has more than eight
blocks, you have to assign the ones you want to control manually.
A
E
C
F H
* Letter-circles are not part of the
actual Quad Cortex display.
While using Stomp mode, press the Up and Down footswitches to
navigate through Presets.
Press and hold either the Up or Down footswitch to navigate
through banks. The Preset name and active footswitch will also
blink intermittently. To conrm the change, press the blinking
footswitch.
Navigating through Presets
Footswitch LEDs
Multiple devices can be assigned to one footswitch.
There is no limit to the number of devices’ bypass status
that can be assigned to a single footswitch.