8
Setting up your Quad Cortex
To turn the Quad Cortex on, connect the power cable to the input
on the back and wait for it to power up.
Tap the name of the mode currently active at the top-right of the
display or press the furthest-right footswitches on the bottom two
rows together.
Before connecting your instrument, make sure the volume wheel is
turned down.
Connect your instrument to Input 1.
Connect your studio monitors, PA, or FRFR cabinet to either XLR
Outs 1/2 or TRS Outs 3/4.
Alternatively, if you want to use headphones, connect them to the
Headphones output.
Quick Start
Turning on your Quad Cortex
Changing Modes
Connecting your gear
While in Preset Mode, press footswitches A-H to switch Presets.
Press the Up/Down footswitches to navigate through the Preset
banks.
Press and hold the bottom-right footswitch to activate the
Tuner.
Browsing Presets
Tuner
If you’re not sure about the
correct input/output levels,
check the I/O Settings section.
To Next Page
Loading...