NIBE FIGHTER 1250
General
Icompleted by the installation engineer when the heat pump is installed
Installation date
Serial number (95)
,
should always be stated with all correspondence with NIBE.
_ _ _ _ _ _ _ _ _ _ _ _ _ _
NIBE FIGHTER 1250
Installer
Type of brine - Mixing proportion/freezing point
Active drilling depth/collector length
Settings
Date ________ Signed ______________________________
Accessories
Installation data
Menu
no.
Name
Fact.
Setting.
Set
EBV(2)
Knob
Name
Factory
set
Mode
Set
1.4 Start temperature
HW
47 100 Fuse 20
1.5 Stop temperature
HW
54 101 Max electrical
output, mode
D
1.6 Stop temp XHW 60 102 Max hot water
temperature, mode
C (65 °C)
1.8 Interval XHW 14
2.1 Curve coeffi cient 9
2.2 Offset heating curve 0
2.3 Flow line temp/Min 15
2.4 Flow line temp/Max 55
5.6 Max return line 53
2.7 Circ. pump controls
heat
100
✓
Product
Exhaust air module FLM 30
Room sensor RG 10
Extra shunt ESV 21
Pool control POOL11
Communication module RCU 11
In order to get the ultimate benefi t from your NIBE
FIGHTER 1250 heat pump you should read through this
Installation and Maintenance Instruction.
- Section A contains information that may be of use to
the end user.
NIBE FIGHTER 1250 is a Swedish made, quality product
offering a long life span and safe operation.
Corrosion protection
Enamel Stainless steel Copper
To Next Page
Loading...
