NIBE FIGHTER 1250
Menu 7.4.3 – 7.4.9 Set time [E]
Monday – Sunday
The time for the day change, e.g. night reduction is chosen
here.
The value can be set between 00:00 and 23:45.
- Factory setting: 00:00-00:00
Menu 7.4.10 Return [E]
Pressing the enter button returns you to Menu 7.4.0
Menu 7.5.0 Timer XHW [E]
Settings are made in the sub-menus of this menu when
extra hot water is required on a specifi c day.
Menu 7.5.1 Timer XHW [E]
Settings whether timer should be “On” or “Off”.
Selection option Off and On.
- Factory setting: Off
Menu 7.5.2 – 7.5.8 Extra HW [E]
Monday – Sunday
Here you select the period for respective days when ex-
tra hot water should be activated. Hours and minutes for
both start and stop are shown. Equal values or the stop
time before the start time mean that extra hot water is not
activated.
The value can be set between 00:00 and 23:45.
- Factory setting: 00:00-00:0
Menu 7.5.9 Return [E]
Pressing the enter button returns you to Menu 7.5.0
Menu 7.6 Reset timers [E]
You can choose here to reset the timers. Automatic return
to “Off” after one minute.
Selection option Off and On.
- Factory setting: Off
Menu 7.7 Return [N]
Pressing the enter button returns you to Menu 7.0.
8.0 Other settings
Menu 8.1.0 Display settings [N]
Settings concerning language and menu type are set on
the sub-menus to this menu.
Menu 8.1.1 Menu type [N]
The menu type is chosen here.
[N] Normal, covers the normal user's needs.
[E] Extended, shows all menus except the service menus.
[S] Service, shows all menus, returns to the previous menu
level 30 minutes after the last button was pressed.
Selection option Normal, Extended or Service.
- Factory setting: Normal
Menu 8.1.2 Language [N]
Language settings are made here.
Menu 8.1.3 Contrast [E]
The display's contrast is set here.
The value can be set between 0 and 31.
- Factory setting: 20
Menu 8.1.4 Light intensity [E]
The light intensity in idle mode is set here. Idle mode starts
30 minutes after the last button was pushed.
Selection option 0=shut-off, 1=low, 2=average.
- Factory setting: 1
Menu 8.1.5 Return [N]
Pressing the enter button returns you to Menu 8.1.0
Menu 8.2.0 Operating mode [E]
Settings regarding auto mode can be made in the sub-
menus to this menu.
Menu 8.2.1 Summer mode temp. [E]
Here you select the average temperature when the heat
pump, in auto mode, shall switch to summer mode. In
summer mode the circulation pump and electrical addition
are blocked, only hot water is produced.
The value is adjustable between 0 and 30 °C
- Factory setting: 25 °C
Menu 8.2.2 Only electric heat [E]
Selected if electric addition is to be used to produce hot
water and heat.
Selection option Off and On.
- Factory setting: Off
Control
E
Incorrect settings in service menus can dam-
age the heat pump
Note!
To Next Page
Loading...
