Nikon D5 - Page 444

420
n
1 Not available with spot metering.
2 Can also be selected with flash unit.
3 qA/A mode selection performed on flash unit using custom settings.
Unless
lens data have been provided using the Non-CPU lens data option in the setup
menu, “A” will be selected when a non-CPU lens is used.
4 Unless lens data have been provided using the Non-CPU lens data option in
the setup menu, non-TTL auto will be selected when a non-CPU lens is used.
5 Can only be selected with camera.
6 Available only during close-up photography.
7 Unless lens data have been provided using the Non-CPU lens data option in
the setup menu, non-TTL auto (A) is used with non-CPU lenses, regardless of
mode selected with flash unit.
8Choice of qA and A depends on the option selected with master flash.
9 Supports the same features as remote flash units with optical AWL.
10 Available only in i-TTL, qA, A, GN, and M flash-control modes.
11 Available only in i-TTL flash control mode or when flash is set to emit monitor
pre-flashes in qA or A flash control mode.
12 Available only in commander mode.
13 Firmware updates for the SB-910 and SB-900 can be performed from the
camera.
• SU-800 Wireless Speedlight Commander: When mounted on a CLS-
compatible camera, the SU-800 can be used as a commander for
SB-5000, SB-910, SB-900, SB-800, SB-700, SB-600, SB-500, or
SB-R200 flash units in up to three groups.
The SU-800 itself is not
equipped with a flash.
Auto FP High-Speed Sync
10
z z zzz z z——
FV lock
11
z z zzz z zzz
AF-assist for multi-area AF zzzz— z
12
———
Red-eye reduction z z zzz ——z —
Camera modeling illumination z z zzz z z——
Unified flash control z ———z ——zz
Camera flash unit firmware update zz
13
z — z ———z
SB-5000
SB-910, SB-900,
SB-800
SB-700 SB-600 SB-500
SU-800
SB-R200
SB-400 SB-300