425
n
Wireless LAN
adapters
(0 279)
• Wireless Transmitter WT-6/WT-5: Connect the WT-6 or WT-5 to
the camera’s peripheral connector to upload pictures over
a wireless network, to control the camera from a
computer running Camera Control Pro 2 (available
separately), or to take and browse pictures remotely from
a computer or smart device.
Note: A wireless network and some basic network knowledge is
required when using a wireless transmitter.
Be sure to update
the wireless transmitter software to the latest version.
Wireless
remote
controllers
• Wireless Remote Controller WR-R10/WR-T10: When a WR-R10
wireless remote controller is attached to ten-pin remote
terminal using a WR-A10 adapter, the camera can be
controlled wirelessly using a WR-T10 wireless remote
controller.
The WR-R10 can also be used to control radio-
controlled flash units.
• Wireless Remote Controller WR-1: WR-1 units are used with
WR-R10 or WR-T10 wireless remote controllers or with
other WR-1 remote controllers, with the WR-1 units
functioning as either transmitters or receivers.
For
example, a WR-1 can be attached to the ten-pin remote
terminal and used as a receiver, allowing the shutter to be
released remotely by another WR-1 acting as a
transmitter.
Note: Be sure the firmware for the WR-R10 and WR-1 has been
updated to the latest version.
For information on firmware
updates, see the Nikon website for your area.
To Next Page
Loading...
