Nikon D5 - Page 451

427
n
HDMI cables
(0 284)
HDMI Cable HC-E1: An HDMI cable with a type C connector for
connection to the camera and a type A connector for
connection to HDMI devices.
Software
• Camera Control Pro 2: Control the camera remotely from a
computer and save photographs directly to the computer
hard disk.
When Camera Control Pro 2 is used to capture
photographs directly to the computer, a PC connection
indicator (c) will appear in the top control panel.
Note: Use the latest versions of Nikon software; see the websites
listed on page xxi for the latest information on supported
operating systems.
At default settings, Nikon
Message Center 2 will periodically check for updates to Nikon
software and firmware while you are logged in to an account
on the computer and the computer is connected to the
Internet.
A message is automatically displayed when an
update is found.
Body caps
Body Cap BF-1B/Body Cap BF-1A: The body cap keeps the mirror,
viewfinder screen, and low-pass filter free of dust when a
lens is not in place.
Remote
terminal
accessories
The D5 is equipped with a ten-pin remote terminal (0 2) for
remote control and automatic photography. The terminal is
provided with a cap, which protects the contacts when the
terminal is not in use.
The following accessories can be used
(all lengths are approximate):
• Remote Cord MC-22/MC-22A: Remote shutter release with blue,
yellow, and black terminals for connection to a remote
shutter-triggering device, allowing control via sound or
electronic signals (length 1 m/3 ft 3 in.).
• Remote Cord MC-30/MC-30A: Remote shutter release; can be
used to reduce camera shake (length 80 cm/2 ft 7 in.).
• Remote Cord MC-36/MC-36A: Remote shutter release; can be
used for interval timer photography or to reduce camera
shake or keep the shutter open during a time exposure
(length 85 cm/2 ft 9 in.).