Nokia 7210 - Page 537

7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
Configuration Guide
System Management
3HE 17358 AAAB TQZZA © 2021 Nokia.
Use subject to Terms available at: www.nokia.com
537
Platforms Supported on all 7210 SAS platforms as described in this document, including platforms
configured in the access-uplink operating mode
Description This command allocates maximum resources for use by ingress filter policies using ipv6
criteria with 128-bit IPv6 addresses.
The resources can be shared with IPv4 ingress filter policies. Refer to the 7210 SAS-M, T,
R6, R12, Mxp, Sx, S Router Configuration Guide for more information on how to allow filter
policies using IPv4 criteria to share resources with filter policies that use IPv6 criteria with
128-bit address and resource allocation and fields available for use.
The no form of this command specifies that the software does not allocate any resources for
use by ingress filter policies using ipv6 criteria with 128-bit IPv6 addresses. If no resources
are allocated for use, the software fails all attempts to associate a service entity (for example,
SAP and IP interface) with an ingress filter policy using this match criteria.
Parameters num-resources — Specifies the maximum amount of resources for use by this filter
match criteria.
Some platforms include the value max. If the user specifies max, the software
allocates one chunk when the first SAP is associated with an ingress filter policy
using this match criteria. It continues to allocate resources to the service entity
associated with an ingress filter policy using this criteria, as long as the total amount
of resources allocated does not exceed the resources allocated to ingress filter
policies (configured with the config system resource-profile ingress-internal-
tcam acl-sap-ingress command) and chunks are available for use.
Values Table 51 lists the parameter values.
Table 51 Number of Resources Available for IPv4-IPv6-128-Match-Enable
Platforms Min value
(per node)
Max value
(per node)
Default
Values
7210 SAS-M (per node) 0 5 0
7210 SAS-T access-uplink mode (per node) 0 7 3
7210 SAS-T Network Mode (per node) 0 6 3
7210 SAS-R6 (per IMMv1) 0 (per IMM) 5 max
7210 SAS-R6 and 7210 SAS-R12 (per
IMMv2)
0 (per IMM) 7 max
7210 SAS-R6 and 7210 SAS-R12 (per IMM-c) 0 (per IMM)
7
1
max
7210 SAS-Mxp (per node) 0 10 max
7210 SAS-Sx 1/10GE (per node) (standalone) 0 6 max
7210 SAS-Sx 1/10GE (standalone-VC) 0 5 max