Maintenance 7-1
7 Maintenance
7.1 Overview
Following a routine maintenance schedule and procedures can prevent part degradation and ensure high
quality performance for every production run. This section covers the following topics:
•
Routine Maintenance Procedures • Lubricating the Cables and Linear Guides
•
Replacing Consumables • Tensioning the Cables
•
Draining the Water Trap • Tensioning the Conveyor Belts
•
Removing the Axis Covers
WARNING! Maintenance procedures should be performed by trained personnel only.
7.2 Safety First
Operation of your S-920 Dispensing System involves heat, air pressure, electrical power, mechanical
devices, and the use of hazardous materials. It is essential that every person servicing or operating the
dispensing system fully understands all hazards, risks, and safety precautions. Refer to Section 2 - Safety
for important safety information.
WARNING! CAUTION!
Consult the Material Safety Data Sheet (MSDS) for all fluids used with the
dispensing system. The MSDS provides material usage instructions, disposal
instructions, and safety precautions.
WARNING! CAUTION!
Make sure the dispensing system ventilation is ON during handling and cleanup
of all materials used with the dispensing system.
7.3 Record Keeping
The type of procedure performed should be recorded in maintenance records for the dispensing system.
Dates, part numbers/serial numbers of replaced parts, names of technicians, and other pertinent data
should be recorded.
To Next Page
Loading...
Need help?
General