4-16 Power-Up and Testing
Item Description
1 Y-Axis Control
2 X-Axis Control
3 Home Button
Figure 4-11 Conveyor Jog Commands Dialog Box
" NOTE For dual conveyor systems, the Conveyor 2 front rail is manually adjustable to allow
pitch variations between Conveyor 1 and Conveyor 2. Both of the rear rails move
synchronously toward the back or front of the machine.
To check fixed-width Conveyor clearance, Safety Interlock, and X-axis movement:
CAUTION! Perform the following procedure only if your dispensing system has been
configured for an application that requires a fixed conveyor width. DO NOT
perform the procedure for adjustable-width conveyor configurations.
" NOTE This procedure assumes that you are already in the FmXP Tools Window. If not, refer to
Steps
2 and 3 in 4.10.5 Conveyor and Conveyor Pneumatics.
1
2
3
To Next Page
Loading...
Need help?
General