Nordson Asymtek Spectrum S-920 User Manual

Power-Up and Testing 4-29
7. With V1_FLUID_AIR ON, adjust the Fluid Air Regulator so that pressure increases and
decreases.
! The air pressure coming from the syringe receiver head should vary with regulator
adjustment.
8. Toggle the
V1_FLUID_AIR bit until it reads OFF (0).
9. This should turn OFF air at the fluid pressure port.
10. Disconnect the syringe receiver head from the fluid pressure port and connect it to the blue
fitting on the pneumatic bulkhead. Also connect a syringe receiver head to the black fitting on
the bulkhead.
! Air should be coming out of the syringe receiver head connected to the black fitting. No
air should be coming out of the syringe receiver head connected to the blue fitting.
11. Locate the bit labeled
V1_VALVE_AIR and toggle the bit until it reads ON (1).
! This should turn OFF the air coming out of the syringe receiver head on the black fitting
and turn ON the air coming out of the syringe receiver head that you connected to the
blue fitting.
12. With
V1_VALVE_AIR ON, adjust the Valve Air Regulator so that pressure increases and
decreases.
! The air pressure coming from the syringe receiver head should vary with
regulator adjustment.
13. Toggle the
V1_VALVE_AIR bit again until it reads OFF (0).
! This should turn OFF the air coming from the blue fitting and turn ON the air coming
from the black fitting on the bulkhead.
14. Disconnect the syringe receiver heads from the blue and black fittings on the pneumatic
bulkhead.
15. If previously disconnected, reconnect all air hoses to the dispensing valve.
16. Close the Dispenser I/O Test dialog box to return to the Tools Window.

Nordson Asymtek Spectrum S-920 Specifications

General

Brand	Nordson
Model	Asymtek Spectrum S-920
Category	Dispenser
Language	English