EasyManua.ls Logo

Notifier ID50 - Evacuation; Silence

Notifier ID50
93 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
ID50 Series Panel - Installation, Commissioning & Configuration Manual
Configuration Mode
67 997-263, Issue 4
September 2002
5.7.3 Evacuation
The Evacuation option has two states, Yes (Y) and No
(N). This option is available with the Fire, Pre-Alarm and
Device Inputs rules. To change the Evacuation setting:
1 Press the 
3
button (using the numeric keypad) to
select the Evacuation option from the menu below.
2 Press the
6
button to select the required setting.
Refer to Section5.7, Control-By-Event Output
Rules for further information.
3 Confirm the selection by pressing the
5
button. To
cancel the selection, press
4
button. In either case
the menu below is re-displayed.
5.7.4 Silence
The Silence option has two states, Yes (Y) and No (N).
This option is available with the Fire, Pre-Alarm and
Device Inputs rules. To change the Silence setting from
the CBE Output Rules menu:
1 Using the numeric keypad, press
4
to select the
Silence option from the menu below.
2 Press the
6
button to select the required setting.
Refer to Section5.7, Control-By-Event Output
Rules for further information.
3 Confirm the selection by pressing
5
. To cancel the
selection, press
4
button. In either case the menu
below is re-displayed.
CBE Rule:01 1:Type 2:Filter 3:Evac
4:Silence 5:Interrupt × : More
CBE Rule:01 Evacuate = [Y]
>:Change 3:Accept < : Cancel
CBE Rule:01 Evacuate = [N]
>:Change 3:Accept < : Cancel
CBE Rule:01 1:Type 2:Filter 3:Evac
4:Silence 5:Interrupt × : More
CBE Rule:01 1:Type 2:Filter 3:Evac
4:Silence 5:Interrupt × : More
CBE Rule:01 Silence = [N]
>:Change 3:Accept < : Cancel
CBE Rule:01 Silence = [Y]
>:Change 3:Accept < : Cancel
CBE Rule:01 1:Type 2:Filter 3:Evac
4:Silence 5:Interrupt × : More
6
3
5
6
5
4

Table of Contents

Related product manuals