ID50 Series Panel - Installation, Commissioning & Configuration Manual
Introduction
4997-263, Issue 4
October 2002
1.6 Ancillary Functions
The following is a list of ancillary functions that are
provided by the ID50 Series panel in addition to the those
required by EN54-2/4. These functions are described in
the section of this manual as referenced (except those
marked thus
*
which are described in 997-264-XXX,
ID50 Series Panel-Operating Manual):
Ancillary Manual
Functions Section Refs.
Site Specific Setup Options 5.5
Access Options 5.9
Voltage Indications *4.11.7
Control-by-Event 5.7
Output modes 5.7.1
Input type pattern 5.7.9
Disable/enablement *4.9
Repeater interface 2.7
Self-learn configuration - manual 5.6.1
Self-learn configuration - auto 5.6.2
Module supervision options 5.6.1
Module silence options 5.7.4
Text editing 5.8
Sensor LED blinking on/off 5.5.7
Bell pulsing ratio 5.5.8
Display of alarm count *4.11.6
Extend delay timer 5.5.3
Sounder Volt-free contact options 4.4.5
Relay drive output option 4.4.6
Extinguishing system features 5.5.4, 5.5.5, 5.5.6,
5.7.1
To Next Page
Loading...
Need help?
General
