23
Installation
4. Installation
4.1 Unpacking and transport
The packaging of the sterilizer consists of a wooden pallet on which the sterilizer is placed, with adequate protective
padding and a corrugated cardboard casing fixed to the pallet with metal staples.
Place the package on a level surface free from clutter to facilitate easy opening and safe extraction of the sterilizer.
There may be a small amount of water inside the chamber due to a residue inside the autoclave hydraulic
circuit.
Lifting, transporting and positioning the sterilizer in the place of installation should be
performed by two people.
It is recommended to keep the packaging in a cool and dry place.
Remove the staples / strapping holding the casing to the pallet.
Remove the cardboard casing.
Remove the accessory kit, corner and edge protection from the sterilizer.
Lift the sterilizer and position it in the place of installation.
To Next Page
Loading...
